3/29/2024 0 Comments Packet tracer activity 3.1.1.5S3(config)# interface f0/11 S3(config-if)# switchport mode access S3(config-if)# no shutdown S2(config)# interface f0/18 S2(config-if)# switchport mode access S2(config-if)# no shutdown S1(config)# interface f0/6 S1(config-if)# switchport mode access S1(config-if)# no shutdown These three ports will be configured for access mode and enabled with the no shutdown command. Refer to the topology diagram to determine which switch ports ( S1, S2, and S3) are activated for end-user device access. Part 1: Configure VLANs Step 1: Enable the user ports on S1, S2, and S3 in access mode. You will also optimize the switched topology using PVST+, PortFast, and BPDU guard. In this activity, you will configure VLANs and trunks, and examine and configure the Spanning Tree Protocol primary and secondary root bridges. Part 3: Configure PortFast and BPDU Guard Background Part 2: Configure Spanning Tree PVST+ and Load Balancing Switch Port Assignment Specifications Ports 3.3.1.5 Packet Tracer – Configuring PVST Addressing Table Device
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |